ark_pab_power_module.md

ARK PAB Power Module

The ARK PAB Power Module is an advanced power module rated for 60A continuous battery current at 20°C ambient. For higher continuous current needs, running multiple power modules in parallel is recommended. Note that at 60A and 20°C without cooling, the 5V regulator is de-rated to a 3A continuous output.

Where to Buy

Order this module from:

• ARK Electronics (US)

Hardware Specifications

• TI INA226 Digital Power Monitor

  • 0.0005 Ohm Shunt
  • I2C Interface

• 5.2V 6A Step-Down Regulator

  • 33V Maximum Input Voltage
  • 5.8V Minimum Input Voltage at 6A Out
  • Output Over-Voltage Protection
  • Output Over-Current Protection

• Connections

  • XT60 Battery Input
  • XT60 Battery Output
  • 6 Pin Molex CLIK-Mate Output
    • Matches ARK PAB Carrier Power Pinout

• Other

  • USA Built
  • FCC Compliant
  • Includes 6 Pin Molex CLIK-Mate Cable

• Additional Information

  • Weight: 17.9 g
  • Dimensions: 4.75 cm x 3.43 cm x 1.15 cm

PX4 Setup

• Enable the SENS_EN_INA226 parameter if it not enabled.
• Reboot the flight controller.

See Also

• ARK PAB Power Module Documentation (ARK Docs)